Deadlift Jack Stands - Custom/DIY
Designed to raise a loaded barbell off the floor to a variety of bar heights.
To follow equipment, you must be logged in.
Deadlift Jack Stands - Custom/DIY Reviews
Based on 5 reviews from Gym Radar users, the Custom/DIY Deadlift Jack Stands - Custom/DIY have an average rating of 3.93 out of 5. They're currently the #16 most-owned Barbell Jack on Gym Radar, with 5 home gyms reporting ownership.
5 Reviews
Performance
3.80 / 5
Build Quality
3.60 / 5
Value
4.40 / 5
User Reviews
Leave a Review
(4.00)
Cheap homemade timber barbell jack.
Made from leftover scrap timber and works perfect for loading/unloading deadlifts. Leverage is far better than the one I had purchased before.
Could have been made better with a wider base and a more robust varnish
(5.00)
These wagon wheels have been awesome and used at a lot of local competitions and an international one. Definitely build to last and gives the opportunity to throw a design in them.
(3.67)
Took the wheels from a spoil of wire on a job site and could almost have an 18” pull with using them. Problem was they are wood and you’d have to be careful about setting them back down. Overtime they broke down a good bit.
(4.00)
Grab your favorite automotive manufacturer's jack stands, add a pair of jack pads, add a set of trailer ramp bumpers, and voilá. These work especially well for accessory bar setup and for use as a landmine jack.
(3.00)
These “jack Stands” allow for multiple different height block pull / rack pull heights without the need for multiple sets of blocks or wagon wheels. They do tend to swing a bit on reps so you really need to control the eccentric or be prepared for the bar to bounce back at you and destroy your shin,
I bought these off a local welder that builds strongman equipment on the side.
Poached in 2024 for $280