I wish it had a little bit more padding, thats my primary complaint. It works well for belt squats, but I honestly use it more for weighted dips and pull ups.

I like this landmine a lot, I just wish that the magnet included to hold the landmine up was stronger. In my rack configuration, I cannot store it fully upright (it needs to run in line with my cross member instead of on the upright, and the magnet is too weak to keep it off the floor in that position. Otherwise, its super smooth, has a barbell pillow inside so I know my bar wont get beat up for using it, and am pretty happy with it.

This is a pretty good tree IF you aren't trying to do multiple rows of 45 lb plates. The sleeves aren't long enough for me to get all my 45 lb plates that I'd like to store on it on a single set of sleeves, so I had to adjust it so that my grip plates are oriented in such a way that the handles on my hampton fusion plates are sort of "interlaced" in a way that it allows that diameter to fit. There would be no way to make it work with some plates, such as my 45lb hulkfit bumpers, so they have to be set underneath some 25lb plates. I drilled a hole in mine to add another weight horn so that I could get an additional horn for 2.5lb change plates, and it works reasonable well for that, but ultimately unless you are looking for a weight tree to store only plates less than a normal 45 lb plate diameter, I'd probably suggest you go otherwise, even though its reasonably sturdy and cost effective.

I like these a lot. The magnets are really strong, and even though it comes with a locking cotter pin, I find I seldom use it unless I'm doing something slightly sketch that I shouldn't be doing. Color selection brings a little pop to my rack as well.

Really great barbell jack for deadlifts, and much easier to store than one that jacks up the whole bar instead of one side at a time. For those with a smaller gym where space is more limited, definitely consider this over a full sized jack.

I wish these were a little tighter to my rack, though I expected some slop being that these were built for true 3x3 uprights and I have a titan x-3. Have shimmed it with UHMW tape but looks like there may be a real shim kit available that I will be inquiring about.

Inexpensive, and they work well for certain things, I used to use them as a second set of collars for superset movements if my primary were being utilized, but now they don't really get any use. Seem like a pretty secure fit for the most part, would be an upgrade over spring collars

My wife uses this much more than I do, but is very happy with the quality at the price. Coating has held up well.